Smith’s WB Marking Paint is a ready-to-use, high solids, fast curing, waterborne polymer ceramic solid color marking paint with a slightly textured finish that offers a low odor product with fast return-to-service & good opacity even at thin coats. Yields a slightly textured, low sheen solid color finish.
Applies with a paint roller / brush or a sprayer then air dries within 1 to 2 hours for full traffic at 72°F (22.2°C).
RECOMMENDED USE:
- Interior or Exterior
- Line Striping
- Pest Control Inspection Areas
- Demarcation lines
- Curbs
- Floor Markings
- Airport tarmacs
SUBSTRATES:
- Concrete
- Well bonded, properly prepared coatings & industrial floor paints
*Test for compatibility over existing fully cured paints / coatings. Apply within previous layer product recoat window unless sanded dull then cleaned for application over resinous or low permeability coatings
- Asphalt walking paths or parking lot lines
- CMU & Cinder Block Walls
- Brick & Pavers
HIGHLIGHTS:
- Fast Air Dry & Return-to-Service, even at 50°F with high air humidity (with up to 90% Ambient Humidity at time of application)
- Durable – Accepts Forklift & Pallet Jack traffic within a few hours
- Single Component – Ready-to-Use & Easy to Apply
- Excellent U.V. Stability – Interior or Exterior Applications
- Long Recoat Window – Allows recoating of subsequent layers or as soon as firm set or for up to 4 days after initial application
- Moisture Resistant once walkable
- Non-Flammable, Slight Odor & Low VOC’s – Use in all regions
- Tenacious early & long-term adhesion to a variety of substrates
- May be applied up to 30 mils WFT in a single layer
- Temperature resistant up constant 150°F
- Good Opacity with 2 coats
- Holds crisp tape line edges – Good bleed through resistance
- Soap & water clean-up while wet
- Meets Federal Specification TT-P-1952F Type III
