Poly PCF-45 - Smith Paints

Smith’s Poly PCF45 is a very low viscosity, fast-setting 2-component solvent-based Polyurethane ideally suited for saturating horizontal cracks (non-moving) and to fill spalls / pop-outs, holes, gouges and other surface imperfections in concrete. Convenient 1 to 1 by volume mix ratio allows for easy mixing and pouring either neat into fine cracks and smaller voids or over sand in larger voids. No primer is necessary. Diamond grind once hard cured.

Smith’s Poly PCF45 may also be used as a pit grout in concrete polishing process where U.V. stability is not a concern. Accepts Smith’s ISC Solid Color Packs which works well when a color similar to the aggregate within the concrete is selected for pit grouting.

Accepts heavy traffic within an hour at 72°F and 50% humidity, diamond grind in as little as 15 minutes or when hard set.

DOCUMENTS:

RECOMMENDED USES:

Bonds to Concrete
Fills Cracks (non-moving), Spalls, Pop-outs & Voids
Freezer & Chiller floor repairs
Above, On or Below Grade Applications
Suspended Deck Repairs (Parking, Bridge, Catwalks, etc.)
Rebuilding Control Joints
For Interior & Exterior applications

HIGHLIGHTS:

Apply from Feather Edge to any depth (when extended with aggregate)
Chemical Resistant
Tenacious Bond to properly prepared concrete
Good Impact Resistance & Load Transfer
Fast Return-to-Service
- Pot Life = 4 minutes
- Grind or Wheeled Traffic = When Fully Hard
- Cures quickly – Even at low application temperatures
- Accepts subsequent layer once diamond ground smooth
Pour Grade – Very thin consistency liquid
Suppresses Minor Cracks from Telegraphing
Resists Aging & Fatigue
Suitable for use over In-floor Radiant Heat systems
Low Viscosity – Penetrates Hairline Cracks as well as dry sand or pea stone for deep repairs
No Priming Necessary
Compliant with VOC Regulations in the following regions: OTC CARB SCAQMD LADCO AIM CANADA

Smith Paint Products®

DOCUMENTS:

DOCUMENTS: