2200 Paxton Street
Harrisburg, PA 17111-1038
Office: 717.233.8781 or
Toll Free: 800.466.8781 (US)
Facsimile: 717.232.5199
2200 Paxton Street
Harrisburg, PA 17111-1038
Office: 717.233.8781
Toll Free: 800.466.8781 (US)
Facsimile: 717.232.5199
Smith’s Hi-Wear 90S is a 3-Component clear or 4-Component pigmented, Low Odor, 90% Solids, Aliphatic Chemical Resistant High Traffic Urethane with a low sheen, slightly textured finish which minimizes the development of traffic patterns. Its high durability, stain and abrasion resistance make it an ideal topcoat for production and heavy manufacturing environments with potential for exposure to forklift and pallet jack castor traffic, exposure to hydraulic fluids, cutting fluids, solvents and many other aggressive chemicals or traffic.
Smith’s CRU’86 is a high performance, single component, high gloss, 86% solids, aliphatic, solvent-based chemical resistant polyurethane topcoat which yields a highly light reflective, smooth finish when applied over a properly prepared coating or primer layer. Smith’s CRU’86 has a long working time, good gloss retention, high abrasion and chemical resistance making it an ideal choice for smooth, gloss finish in aircraft hangars, showrooms, etc. with moderate traffic environments which desire a high gloss finish with less odor during installation.
Smith’s MCU-60 is a ready-to-use single component, 60% solids, solvent-based, moisture-cured polyurethane topcoat which does not compromise performance due to the advanced chemistry involved with its formulation. This yields better application control in a wider range of temperature and humidity applications which tend to cause issues with typical 2-component moisture-cured urethane topcoats especially in warmer and/or more humid installation conditions. Smith’s MCU-60 performs well in industrial production / manufacturing environments, warehouses, airplane hangars, showrooms, etc. which desire a durable, stain and chemical resistant wear surface with some cost savings and/or a faster return to full traffic (above 70°F vs. other polyurethane topcoats) where odor during installation is not a limiting factor.
Smith’s Poly-WB is a 2-Component, high performance waterborne Polyester Polyurethane for use as a hard, durable protective or maintenance wear surface over decorative concrete, pavers, concrete stains, as well as a variety of floor coating systems with moderate to heavy traffic. Yields good gloss retention, better chemical & stain resistance versus traditional 2-Component water-based Polyurethanes. Primer is required for use direct-to-concrete, stone or paver applications.
Smith’s Poly-SEAL is a single component, fast drying, waterborne polyurethane polymer fused with a cross-linking acrylic which achieves a tenacious bond to approved substrates, with very good resilience, longevity, U.V. stability and wear.
Smith’s Poly-SEAL may be used as a primer for interior and exterior direct-to-concrete applications prior to Smith’s Poly-WB topcoat, as a seal coat to lock down Vinyl Chip prior for residential garage floor systems, finish for Terrazzo as a replacement for traditional floor wax in addition to a standalone architectural and decorative concrete sealer for concrete overlays, Stucco, pavers and more.
Smith’s Poly-FLEX is a Heavy-Duty, 2-Component, Moisture Tolerant, Semi-Rigid Polyurethane Flowable Resurfacing Compound with good elongation characteristics to aid in suppressing minor cracks from telegraphing through yet rigid enough for traditional applications. Walkable in roughly 2 ½ hours and accepts subsequent layers/systems in as little as 4 hours. Applies from a minimum of 30 mils up to 5 inches in a single lift over concrete. Tenaciously bonds to a variety of substrates.
